|
|
HARMONY®
10/27/2009
Harmony® Interior Latex Flat is a durable low-odour, anti-microbial (this product contains agents which inhibit the growth of Microbes onthe surface of this paint film), formulation without silica. This product can be used without typical odour complaints, in occupied areas such as hospitals, hotels, office buildings, residential, schools etc, due to the very low odour during application and drying.
T E C H N I C A L C H A R A C T E R I S T I C S
Coverage: 9-10 m2/l
Finish Gloss: 0-5 units @ 85o
Drying time @ 50 % RH, 5oC (Temperature and Humidity dependent)
Vehicle type: EVA
Touch dry: 1 hour
Recoat: 4 hours
Volume solids: 41±2%
Weight solids: 60±2%
Density: 1,45 kg/L
European Union Limit value for this product (cat A/a): 75g/l (2007) / 30g/l (2010). This product contains max. 2g/l VOC.
S U R F A C E P R E P A R A T I O N
> New Surfaces: All surfaces to be painted with Harmony® should be ins ound and dry condition and free from any oil, grease or any other material that cuold prevent good adhesion of Harmony® to the surface. Porous surfaces should be treated with Masonry Conditioner or PrepPrite Masonry Primer by Sherwin-Williams®.
> Previously Painted Surfaces: Remove all dirt, loose or peeling paint, grease, rust and other contaminants that amy interfere with adhesion of paint. Dull glossy surfaces by using fine sandpaper or an abrasive cleaner. Clean and wash the surface. Apply an appropriate patching material (Shrink-Free Sparkling by Sherwin-Williams®.) to cracks, nail holes or other surface imperfections and allow ot cure. Surface must be dry prior to painting.
> Plaster: New or old plaster should be dry, cured and hard. Soft, porous or powdery plaster should be treated with Masonry Conditioner by Sherwin-Williams and be allowed to dry before painting.
A P P L I C A T I O N:
> Application tempeture: 5 - 43οC
> Relative Humidity: 85% Max.
> Methods: Brush, Roller or Airless spray
> Reducer: Water
> Reduction for priming: Up to 50% depending on porosity of substrate.
> Reduction for additional coats: Up to 10%
> PH of surface: Less than 10
H E A L T H A N D S A F E T Y M E A S U R E S
> Keep away from children.
> In case of eye contact, flush with large amounts of water and seek medical advice.
> If swallowed get medical advice immediately, showing the container.
> Apply in well ventilated areas.
C L E A N - U P
Use soap and water. Be sure to flush equipment after cleaning with solvent to prevent rusting of metal parts. Follow suppliers safety cautions.
P A C K I N G: 1L, 4L, 8L and 20L.
S T O R A G E: Protect from freezing and direct sunlight.
Note 1: The Sherwin-Williams product range is manufactured in Cyprus by Peletico Ltd, under lisence from the Sherwin-Williams Company, Cleveland, Ohio USA, owner of the Registered Trademarks.
Note 2: The information supplied in our literature or given by our employees, agents or distributors concerning the use of our products is basedupon extensive experience and given in good faith in order to help you. We guarantee the consistent high quality of our products; however, as we have no control over site conditions of the executions of the work, we cannot accept any liability for any loss or damage, which may arise as a result thereof.
|